Residual Stresses in Shot-Peened Mechanical Structural Carbon Steel Using High-Energy X-Rays

Chang-Hwan Bae; Seung-In Lim; Chang-Suk Han

doi:10.3740/MRSK.2025.35.2.58

All Issue

2025 Vol.35, Issue 2 Preview Page Next Page

Research Paper

Residual Stresses in Shot-Peened Mechanical Structural Carbon Steel Using High-Energy X-Rays

27 February 2025. pp. 58-68

PDF XML

Abstract

X-ray diffraction is widely used as a non-destructive method for measuring residual stress in crystalline materials, and is particularly useful as a technique for controlling residual stress that has been introduced during the heat treatment or surface treatment of metallic materials. Neutron stress measurement is gaining attention as an internal material measurement method. It complements the demerits of the X-ray method in that it measures stress in a very thin surface layer. The neutron stress measurement method, like the X-ray method, is based on the principle of crystal diffraction, and its penetration depth is about 1,000 times greater than that of the X-ray method and is suitable for measuring the inside of a material. This study investigated the residual stress measurement method using the sin²ψ method using shot-peened mechanical structural carbon steel. The non-destructive measurement using high-energy X-rays was compared with the residual stress measured using conventional laboratory X-rays, and the following results were obtained. The high intensity diffraction angles using high-energy X-rays are low, but can be measured with sufficient precision. Interpreting the three diffractions 633, 552, and 721 as a single diffraction profile allowed stress measurements to be made, and the calculated value was close to the weighted average of the intensity ratios. The results of the high-energy X-ray residual stress measurements were in good agreement with the results from laboratory X-rays, confirming the usefulness of this method as a non-destructive method of assessing stress deep inside materials.

Keywords

X-ray diffraction

non-destructive measurement method

residual stress

sin²ψ method

high-energy X-ray

References

C.-S. Han and C.-W. Lee, Korean J. Mater. Res., 33, 205 (2023).

10.3740/MRSK.2023.33.5.205

C.-S. Han, S.-S. Park and M.-G. Chun, J. Korean Phys. Soc., 84, 779 (2024).

10.1007/s40042-024-01054-2

C.-S. Han, M.-H. Wang and H.-J. Jeong, J. Korean Phys. Soc., 84, 538 (2024).

10.1007/s40042-024-01008-8

S. Y. Kim, E. Y. Kim, S. D. Bu, J. K. Han, D. S. Song, J. S. Lim and K.-S. An, J. Korean Phys. Soc., 74, 1027 (2019).

10.3938/jkps.74.1027

S.-Y. Kim, G.-E. Lee and I.-H. Kim, J. Korean Phys. Soc., 74, 967 (2019).

10.3938/jkps.74.967

Y. Kim, J. Kim, K. W. Ahn, D. Y. Noh, C. Kim, H. C. Kang, H. C. Lee and C.-J. Yu, J. Korean Phys. Soc., 70, 849 (2017).

10.3938/jkps.70.849

A. Nouraddini-Shahabadi, M. R. Rezaie, Y. Hiedarizadeh and S. Mohammadi, J. Korean Phys. Soc., 84, 672 (2024).

10.1007/s40042-024-01039-1

B. Chang, J. W. Jeong, H.-J. Noh and S. S. Lee, J. Korean Phys. Soc., 83, 756 (2023).

10.1007/s40042-023-00907-6

S. Kang, J. Kim, J. H. Kim, H. Park, H. Park and Y. S. Yoon, J. Korean Phys. Soc., 82, 586 (2023).

10.1007/s40042-023-00713-0

V. P. Singh and K. K. Sharma, J. Ultra Sci. Phys. Sci., Sect. B, 34, 37 (2022).

10.22147/jusps-B/340401

A. N. Hopersky and A. M. Nadolinsky, JETP Lett., 115, 434 (2022).

10.1134/S0021364022100423

B. Mohammedi, H. Benkharfia, B. Beladel, N. Mellel, K. Bessine and N. Moulai, At. Indones., 49, 151 (2023).

10.55981/aij.2023.1275

J. Akbar, X. Bin, L. Hou, J. H. Marsh and X. Liu, Opt. Quantum Electron., 55, 129 (2023).

10.1007/s11082-022-04334-y

C. C. Ahia and E. L. Meyer, J. Mater. Sci.: Mater. Electron., 34, 1443 (2023).

10.1007/s10854-023-10839-3

W. Fang, J. Chen, F. Cai, Z. Chai and F. Ba, Thin Solid Films, 787, 140142 (2023).

10.1016/j.tsf.2023.140142

Y. Huang, G. Deng, Z. Chen, K. Saito, T. Tanaka and Q. Guo, Jpn. J. Appl. Phys., 62, 061004 (2023).

10.35848/1347-4065/acd59b

S. Harada, T. Nishigaki, N. Kitagawa, K. Ishiji, K. Hanada, A. Tanaka and K. Morishima, J. Electron. Mater., 52, 2951 (2023).

10.1007/s11664-023-10270-8

B. Ortner, Int. J. Mater. Res., 96, 1049 (2022).

10.1515/ijmr-2005-0181

I. G. McDonald, W. M. Moehlenkamp, D. Arola and J. Wang, Exp. Mech., 59, 111 (2019).

10.1007/s11340-018-00447-2

W.-E. Fu, Y.-Q. Chang, B.-C. He and C.-L. Wu, Thin Solid Films, 544, 201 (2013).

10.1016/j.tsf.2013.03.121

Y. Noda, T. Shobu and N. Ikeda, Nihon Kessho Gakkaishi, 42, 12 (2000).

10.5940/jcrsj.42.12

H. M. Rietveld, Phys. Scr., 89, 098002 (2014).

10.1088/0031-8949/89/9/098002

E. E. Sileo and S. E. Jacobo, Phys. B, 354, 241 (2004).

10.1016/j.physb.2004.10.002

W. He, S. Park, D. Shin, S. Yoon, Y. Wu, J. Qiu, Y. Hwang, H. Kim and B. Kim, J. Korean Phys. Soc., 58, 575 (2011).

10.3938/jkps.58.575

D.-H. Lee, S.-J. Kwon, W.-H. You, J.-B. Choi and Y.-J. Kim, J. Korean Phys. Soc., 54, 1115 (2009).

10.3938/jkps.54.1115

F. Lyu, Y. Li, Z. Shi, X. Huang, Y. Zeng and J. Lin, Mater. Sci. Eng., A, 773, 138859 (2020).

10.1016/j.msea.2019.138859

K. Ogawa and T. Asano, J. Soc. Mater. Sci., Jpn., 48, 1360 (1999).

10.2472/jsms.48.1360

K. L. Wlodarczyk, A. A. Lopes, P. Blair, M. M. Maroto-Valer and D. P. Hand, J. Manuf. Mater. Process., 3, 14 (2019).

10.3390/jmmp3010014

S. Risal, N. Singh, A. I. Duff, Y. Yao, L. Sun, S. Risal and W. Zhu, Materials, 16, 3779 (2023).

10.3390/ma1610377937241405PMC10222196

M. Zhang, H.-I. Sun and J.-W. He, Trans. Nonferrous Met. Soc. China, 11, 63 (2001).

Information

Publisher :Materials Research Society of Korea
Publisher(Ko) :한국재료학회
Journal Title :Korean Journal of Materials Research
Journal Title(Ko) :한국재료학회지
Volume : 35
No :2
Pages :58-68
Received Date : 2025-01-02
Revised Date : 2025-01-02
Accepted Date : 2025-01-21
DOI :https://doi.org/10.3740/MRSK.2025.35.2.58

Korean Journal of Materials Research ISSN:1225-0562(Print) 2287-7258(Online) 한국재료학회지

All Issue